chamfer
英 [ˈtʃæmfə(r)]
美 [ˈtʃæmfər]
n. 斜切面; 削角
复数：chamfers 现在分词：chamfering 过去分词：chamfered 过去式：chamfered 第三人称单数：chamfers
COCA.44768
牛津词典
noun
- 斜切面；削角
a cut made along an edge or on a corner so that it slopes rather than being at 90˚
英英释义
noun
verb
双语例句
- CHAMFER: The flat surface formed by cutting away the sharp edges of two meeting surfaces.
倒角：两个表面相交处，通过切掉尖锐边缘形成的平面。 - Based on physical simulation of edge rolling process in Trimming-Free Plate rolling method, the affection of V rolling and chamfer rolling on the plate profile is analyzed.
基于中厚板无切边轧制法中立轧轧边变形的物理模拟，分析了平辊立轧与倒棱轧制对中厚板断面形状的影响。 - This paper analyzes the lack of traditional settingout method and the advantage of digitalization settingout method when analyzing settingout of chamfer stake in cubic meter of earth and stone.
分析了土石方工程中坡口桩放样时，传统放样方法的不足和数字化放样方法的优点。 - After too large tooth resultant force is eliminated, tooth chamfer bone is OK proper motion rehabilitate, of the tooth become loose degree also return to normal subsequently;
当过大的牙合力消除后，牙槽骨可以自行修复，牙齿的松动度也随之恢复正常； - Select those front edges and chamfer them then click apply and chamfer it again but this time with a lower value.
选择前面的边并倒角，然后单击应用并以较低的值再次倒角。 - The specialized inspector inspects the bore diameter, pitch, chamfer and finish degree of bore wall.
加工完成后由专门检验员检验孔径、孔距、倒角大小、孔壁光洁度。 - Or just the dimensions related to big chamfer?
或者只是尺寸大倒角？ - The effects of rolling parameters such as plate width, roll contours, chamfer and straight chamfer parameters on the contact pressure distribution were studied.
研究结果表明，在轧制能力范围内，轧件越宽，轧辊采用凹辊型可以使辊身部的辊间压力分布更为均匀； - Also, the chamfer of the stay vanes entrance and the surface roughness of the flow channel were optimized by the numerical investigations.
亦对固定导叶入口冲角、涡壳壁面粗糙度对流动的影响进行了定量分析。 - RECHAMFER: Defect on radii and chamfer; defective chamfer such as nicks that are considered to be repairable.
重新倒角：可被重新修复的倒角缺陷，例如划痕。