empennage
英
美
n. 尾翼；尾翼面；尾部; 缩写词为EMP
复数：empennages
英英释义
noun
- the rear part of an aircraft
双语例句
- The tailless aircrafts are regarded as a developing way of the new type aircrafts, which have non-linear characteristic of strong coupling in the lateral-directional mode and in between lateral-directional mode and longitudinal mode due to lack of empennage and even fuselage.
无尾飞机是新型飞机的研究方向，由于其没有尾翼甚至机身，导致横侧向模态自身以及横侧向模态与纵向模态之间存有强耦合非线性特性。 - The method using feedback linearization of combined control of cavitation device and empennage and synovial control algorithm are simulated by MATLAB to test control effects.
简单介绍空化器及尾翼联合控制的反馈线性化方法及滑模控制算法，并对两种控制算法分别进行MATLAB仿真，用以检验控制效果。 - The design is successfully applied to a load-simulated test bed of missiles 'wing and its empennage clung to a certain institute. The accepted experiments of control method and software have been done, through which the tests of the products have been completed.
论文将其设计成功的应用于某研究所的导弹弹翼、尾翼负载模拟实验台，完成了控制律和软件的验收实验，成功的进行了产品测试。 - The boundary layer measurement has also been executed on the afterbody of the fuselage with empennage and engine cabins.
并应用微型总压管进行了后体的边界层测量实验，得到了边界层平均速度分布。 - After the external input servo ( empennage) reset command, posture control circuit output PWM pulse signal to reset the servo and start FLASH into the writing mode to record data.
外部输入舵机（尾翼）复位命令后，姿态控制电路输出PWM脉冲信号进行舵机复位，并启动FLASH进入写状态，记录数据。 - Based on test and simulation of aircraft windshield, the anti-bird impact design guide line of aircraft typical structures for radome and leading edge of wing and empennage is discussed.
最后在对飞机典型结构风挡、雷达罩、机尾翼前缘的试验与仿真研究的基础上，对飞机典型结构的抗鸟撞设计准则进行了探讨。 - Effectively Analyzing Aeroelastic Model Empirical Design for Empennage Non-Lift Type Buffeting and Its Wind Tunnel Test Data
尾翼气动弹性抖振模型设计与抖振试验研究 - Influence of empennage on flow over upswept after-body
尾翼对民机后体流动特性的影响 - Two methods are used in this paper to analysis the flight dynamic performance for UAV without empennage by qualitative and quantitative analysis. One is calculating two longitudinal modes by linearizing the basic motion equations. The other is three-dimensional flight simulation research with complete motion equations.
文章主要运用了基本运动方程线化进行基本模态计算分析和建立全量方程进行三维虚拟飞行仿真研究两种方法来定量与定性的分析与评估无尾式无人机的飞行动力学特性。 - Utilizing the functions of CATIA software in Reverse Engineering deals with point cloud data of mobile empennage that is gained from laser measuring and reconstitute the curved surface. Gains the solid model that Rapid Prototyping requires.
在逆向工程中应用CATIA软件处理激光测量的方法得到的汽车尾部局部点云数据，进行曲面重构，获昨快速原型所需的实体模型。