tangency

英

美

网络  切线连续; 接触; 相切; 切向参考; 切矢连续

复数：tangencies　

英英释义

noun

• (electronics) a junction where things (as two electrical conductors) touch or are in physical contact
  1. they forget to solder the contacts
  Synonym:contact
• the state of being tangent

双语例句

• That would mean that everybody is holding that same portfolio of risky assets and nobody is different, they're only different in how what proportions they hold the risky the tangency portfolio.
  这就意味着每个人，都持有相同风险资产投资组合，每人都是一样的，他们唯一的不同在于-，他们所持有风险资产的比例-，也就是切线资产组合。
• Now, he's using a much longer sample than I did, so he's not going to get this tangency portfolio that I did.
  他的样本跨度比我的要大多了，所以他得出的切线资产组合会和我的不同。
• This is just as point of tangency of this dissertation.
  这正是本研究的切入点。
• The tangency portfolio is the portfolio that one should hold.
  切点投资组合就是我们应该持有的投资组合。
• The optimal allocation of the certainty and severity of penalty under the cost restrain is the point of tangency of the curve of equal deterrence and the curve of equal cost of deterrence.
  成本约束下的刑罚确定性与严厉性的最优配置是等威慑水平曲线与等威慑支出曲线的切点。
• Then finally, the final step is to find what is the tangency line that goes through the riskless rate.
  在最后，最终的步骤是找出一条，穿过无风险收益率的切线。
• Taking the reform in curriculum system, content of courses and teaching method as our point of tangency;
  以课程体系、教学内容和教学方法的改革为切入点，大力加强传统专业的更新改造；
• The essence of arc joining is making the tangency of the arc and line or the arc and arc. The programmed Drawing method of arc joining based on AutoCAD secondary-development is studied in this article. The Visual LISP drawing program of arc joining is merited.
  圆弧连接的本质就是使圆弧与直线或圆弧与圆弧相切，在此研究了基于AutoCAD二次开发的圆弧连接程序化绘制方法，用VISUALLISP语言编程建立了圆弧连接通用绘图程序。
• Given a NURBS curve, perturbation for control points is chosen and the LSM ( Least Square Method) is used to modify the geometric features such as position, tangency or curvature of the selected parametric point on the given curve.
  通过对NURBS曲线的控制顶点扰动，采用最小二乘法修改曲线上给定一点处的位置、切矢和曲率等几何特征，并讨论了多点几何特征同时修改的情况。
• This paper studied the case that there is a known point of tangency of a circle and a parabola while the center of the circle is on the recession of the parabola.
  应用数形结合的方法，研究了已知圆与抛物线有一个切点，而圆心在切点处抛物线的凹向的情形。